Skip to main content
Article | Center for Nanoscale Materials

Frequency Stabilization in Nonlinear Micromechanical Oscillators

Using Center for Nanoscale Materials (CNM) expertise in the design and fabrication of micro- and nanoscale devices, a new strategy for engineering low-frequency noise oscillators capitalizes on the intrinsic nonlinear phenomena of micro- and nanomechanical resonators. A fundamental limitation of such resonators was addressed by a team of researchers from the Nanofabrication & Devices Group working with CNICT, Argentina.

Mechanical oscillators are an essential component of nearly every electronic system requiring a frequency reference for timekeeping or synchronization. They are also widely used in frequency-shift-based sensors of mass, force, and magnetic field. Unfortunately, as the dimensions of vibrating semiconductor structures are reduced to the micro- and nanoscale, their dynamic response at the amplitudes needed for operation frequently becomes nonlinear.

In addition, large displacement instabilities and excessive frequency noise considerably degrade their performance. In this régime, unlike the linear case, the resonant frequency has a strong dependence with the oscillation amplitude. This increases frequency noise of the oscillator considerably, and thus, the benefits of operating at higher amplitudes are undone.

The limitation was overcome by coupling two different vibrational modes through an internal resonance, where the energy exchange between modes is such that the resonance of one mode absorbs the amplitude and frequency fluctuations of the other. This effectively acts as a stabilizing mechanical negative feedback loop.

The result demonstrates that very low-frequency noise performance is possible in the nonlinear régime and provides a path to replace quartz oscillators with nanoelectromechanical systems technology.

D. Antonio, D. Zanette, and D. Lopez (CNM), Frequency stabilization in nonlinear micromechanical oscillators,” Nature Communications, 3, 806 (2012) [doi: 10.1038/ncomms1813]

In the News